Tektronix Keithley SourceMeter 2470, Reference Manual

Page: 410 / 995

2470 High Voltage SourceMeter Instrument Reference Manual Section 12: SCPI command reference
2470-901-01 Rev. A /
May
2019 12-23
Also see
:CALCulate2:<function>:LIMit<Y>:CLEar:AUTO (on page 12-17)
:CALCulate2:<function>:LIMit<Y>:CLEar[:IMMediate] (on page 12-18)
:CALCulate2:<function>:LIMit<Y>:FAIL? (on page 12-19)
:CALCulate2:<function>:LIMit<Y>:LOWer[:DATA] (on page 12-20)
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA] (on page 12-23)
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA]
This command specifies the upper limit for a limit test.
Type Affected by Where saved Default value
Command and query Recall settings
Instrument reset
Power cycle
Measure configuration list Save settings
Measure configuration list 1
Usage
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA] <value>
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA] <DEF|MIN|MAX>
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA]?
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA]? <DEF|MIN|MAX>
<function> The measure function:

Current:
CURRent[:DC]

Resistance:
RESistance

Voltage:
VOLTage[:DC]
<Y>
Limit number:
1
or
2
<value>
The value of the upper limit (
−
9.11 to +9.11) or
DEFault
,
MINimum
, or
MAXimum
<DEF|MIN|MAX> The
DEFault
,
MINimum
, or
MAXimum
value
Details
This command sets the high limit for the limit
Y
test for the selected measurement function. When limit
Y
testing is enabled, the instrument generates a fail indication when the measurement value is more
than this value.
If you send this command without the
<function>
parameter, it will set the limit for all measure
functions.