S500 Integrated Test System Administrative Guide
Specifications are subject to change without notice
PA-939 Rev. C / October 2014
5 of 33
Unpacking system components
Inspect the shock sensor located on the outside of the shipping box (see next figure). If the shock sensor indicates a shock
condition, conduct a very thorough inspection of all components contained in the system cabinet. Also, check the "TIP N
TELL" indicator to ensure that the crate has not been tipped over (see the appropriate figure). Report any damage to the
shipping agent immediately. Carefully remove all system components from the crate. While unpacking, make sure there is no
component damage. Please reuse or recycle packaging materials in accordance with your local requirements.
Figure 3: S500 Crate shock sensor
Figure 4: S500 Crate tipping indicator
You will need at least two people to unpack and move the S500 system cabinet.
1. Remove the clamps from the crate using a standard screwdriver.
Figure 5: Removing the clamps
2. Open the front of the crate. The front is identified by the wooden ramp support attached across the panel (see next
figure).
3. Make sure the ramp support is pulled away from the crate. It is held in place with Velcro.
