Tektronix KEITHLEY 707B, Reference Manual

Page: 381 / 534

Section 7: TSP command reference Models 707B and 708B Switching Matrix Reference Manual
7-150 707B-901-01 Rev. B / January 2015
scan.trigger.arm.set()
This function sets the arm event detector to the detected state.
Type TSP-Link accessible Affected by Where saved Default value
Function Yes
Usage
scan.trigger.arm.set()
Details
This function sets the arm event detector of the trigger model to the detected state.
Example
scan.trigger.arm.set() Sets the arm event detector to the detected
state.
Also see
scan.trigger.arm.clear() (on page 7-149)
scan.trigger.arm.stimulus (on page 7-150)
Trigger model (on page 3-1)
Scanning and triggering (on page 3-1)
scan.trigger.arm.stimulus
This attribute determines which event starts the scan.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes
Instrument reset
Recall setup
Scan reset Create configuration script
Save setup
0
Usage
eventID = scan.trigger.arm.stimulus
scan.trigger.arm.stimulus = eventID
eventID
Trigger stimulus used for the channel action (arm layer); see Details
Details
This attribute selects which events cause the arm event detector to enter the detected state.
Set this attribute to 0 to start the scan without waiting for an event.
eventID
may be one of the following trigger event IDs.
•
digio.trigger[ N ].EVENT_ID
: An edge (either rising, falling, or either based on the configuration of
the line) on the digital input line.
•
display.trigger.EVENT_ID
: The trigger key on the front panel is pressed.
•
trigger.EVENT_ID
: A *trg message on the active command interface. If GPIB is the active command
interface, a GET message will also generate this event.
•
trigger.blender[ N ].EVENT_ID
: A combination of configured events has occurred
•
trigger.timer[ N ].EVENT_ID
: A delay expired.