5. With the top cover of the switching card facing up, align
the card edge into the card guide of the slot, as shown in
the following figure.
6. Slide in the card. For approximately the last ¼ inch,
press in firmly to mate the module connector to the
mainframe connector.
7.
On each side of the module, there is a mounting
screw. Use the flat‑bladed screwdriver to tighten these
two screws to secure the module to the mainframe.
Do not overtighten.
8. Reconnect the power line cable and any other cables to
the rear panel.
NOTE
All signal wiring to devices and instruments is done through
the switch cards. Refer to the switch card documentation for
additional information.
1
Card guide (part of Series 3700A instrument)
2
Card edge (part of card)
3
Card
4
Mounting screws (part of card)
4
2
3
1
