30
2268S-901-01 Rev. A / January 2015
In this section:
This section provides the procedures for local (front panel) operation such as:
•
Configuring settings.
•
Operating in constant voltage mode, constant current mode, and constant power
mode).
•
Using the protection features.
•
Using multiple power supplies
INTRODUCTION
Once you have installed the power supply and connected both the AC input power and the
load (covered in “Installation” on page 17), the power supply is ready for local operation. To
turn the power supply on, see “Powering the Power Supply On/Off” on page 23
CONFIGURING SETTINGS FROM THE FRONT PANEL
The 9-position mode control is used with the rotary Adjust/Enter control to configure settings
in local operation. See Figure 2 for location of the front panel features.
Using the 9-position mode control, select one of nine modes: VOLTS, AMPS, FLD, PRT,
SAV, RCL, CAP, and VAP. See Figure 9 below and the table that follows for detailed
information on the nine modes.
Figure 9: 9-Position Mode Control
Using the Rotary Adjust/Enter Control
The rotary Adjust/Enter control is used to change settings and set the value selected. The
front panel displays information on the output voltage and output current displays. Each
display has a maximum of four characters that are made up of 7 segments.
Section 3
Local Operation
Summary of Contents for Keithley 2268 Series
Page 102: ......
