2-61
Installation
Installing SD Series Tablet
1.
Connect the graphics tablet to the
POINTING DEVICE
input port on the back of
the switcher Control Panel.
2.
The Control Panel CPU Board RS-232 jumper blocks must be set to the “DTE”
position.
Model 4000-2:
■
Open the Control Panel lid and locate the Control Panel CPU Board. Lo-
cate the two RS232 jumper blocks (2 pins each) labeled J3 at the top, mid-
dle, of the board. Set the blocks to the “DTE” setting (vertical as you view
the board from the front of the panel).
Model 4000-3:
■
Open the Upper Control Panel lid and locate the Control Panel CPU
Board. Locate the two RS232 jumper blocks (2 pins each) labeled J11 in the
center of the board. Set the blocks to the “DTE” setting (vertical as you
view the board from the front of the panel).
NOTE:
Refer to the Model 4000 User Guide for Drawing Tablet operational information.
Summary of Contents for Grass Valley 4000
