Tektronix Grass Valley 4000, Installation And Service

Page: 40 / 286

2-6
Section 2 — Installation
Model 4000-2A Cutout Dimensions
1. Using the dimensions shown in Figure 2-2 , make cutouts in the console to
accommodate the Model 4000-2A Control Panel.
2. Carefully place the Control Panel into the cutout and mark the pilot hole
locations for the six anchor screws. Note that the ends of the panel tub have
been designed to grasp for removal.
3. Remove the Control Panel and use a 1/8” (3 mm) bit to drill six pilot holes to
secure the Control Panel to the console.
WARNING
Do not lift the Control Panel by the lid or the transition lever arms. Be careful
when opening or closing the panel lid. The gas shock supports may cause
the lid to open or close abruptly, causing possible injury or damage to the
equipment. Always lift the Control Panel by holding onto the tub.
M30-002-213
47.43"
(120.47cm)
24.10"
(61.21cm)
24.45"
(62.15cm)
44.20"
(112.77cm)
22.10"
(56.13cm)
1/8" Diameter Pilot Hole for #6 (M4)
Screw (6 places where indicated)
1.63"
(4.13cm)
0.173"
(0.44cm)
Rear
Front
Limits of
Cutout
Area
4000-2A
Figure 2-2. Model 4000-2 A Control Panel Console Cutout Dimensions