Tektronix Grass Valley 4000, Installation And Service, Page: 39 / 286

2-5
Installation
Installation
The following procedures contain the instructions necessary to install the Control
Panel, Signal Processor Frame, and Frame power supply. Procedures are also
included for optional modules and cable installation. Before proceeding, read and
understand all precautions and notes.
Model 4000-2A/B Control Panel Installation
This installation does not require countersunk or beveled edges. The tub slips into
the cutout from the top and is held in place by an overhanging lip secured by six
screws. To install the Control Panel in the console, proceed with the following
steps.
NOTE: The control panel should be installed on as flat a surface as possible. It is not
recommended to have more than a 10 degree tilt, as this would add excessive weight on the
gas shocks supporting the Control Panel top.
Be sure to leave a minimum of 6.0” (15.3 cm) of clear space inside the console behind the
Control Panel for control, signal, and power cables and connectors.
Also, be sure to leave a minimum of 5.3” (13.5 cm) of clear space behind the Control Panel
so the lid can be fully opened, as shown in
Figure 2-1 .
25.41"
(64.54CM)
1.125"
(2.86 CM)
7.38"
(18.75CM)
23.86"
(60.61CM)
TP0349-006
UNLESS OTHERWISE SPECIFIED:
1. DIMENSION TOLERANCE: .XX = .10, ANGLES = 2 1/2
°
2. ALL DIMENSIONS IN INCHES ", (CM)
25.10"
(63.75CM)
5.31"
(13.49CM)
75
°
Note:
This drawing contains physical panel dimensions.
Table dimensions are not shown.
Figure 2-1. Model 4000 -2A/B Control Panel Profile