Command Descriptions
Table 2-29: Event status enable register (1 = enable) (cont.)
Bit
Weight
Enables
3
8
DDE, Device Dependent
Error
2
4
QYE, Query Error
1
2
RQC, Request Control (not
used)
0
1
Operation Complete
Returns
<Decimal data>
Examples
*ESE 36
In this example, command error bit 5, and query error bit 2, will set the ESB-bit of
the Status Byte if these errors occur.
*ESR?
Reads out the contents of the standard event status register. Reading the Standard
Event Status Register clears the register.
Group
Common
Syntax
*ESR?
Returns
<dec.data> = the sum (between 0 and 255) of all bits that are true. (See Table 2-29
on page 2-53.)
FETCh:ARRay? (Query Only)
FETCh:ARRay?
query differs from the
query by fetching
several measuring results at once.
An array of measurements must
fi
rst be made by the commands:
MEASure:ARRay:<MeasuringFunction>?
or
.
If the array size is set to a positive value, the
fi
rst measurement made is the
fi
rst
result to be fetched.
2-54
FCA3000, FCA3100, MCA3000 Series Programmer Manual
Summary of Contents for FCA3000 Series
