Tektronix ECO422D, Instruction Manual, Page: 26 / 128

Getting Started
1- 6
ECO422D SD/HD Changeover Unit Instruction Manual
Stop latch
Figure 1- 7: Installing or removing the rack slides
Rack Adjustments.
After installation, if not properly adjusted, the slide tracks
may bind. To adjust the tracks, slide the instrument out about 10 inches, slightly
loosen the screws holding the tracks to the front rails, and allow the tracks to
seek an unbound position. Retighten the screws and check the tracks for smooth
operation by sliding the instrument in and out of the rack several times.
Once the instrument is in place within the rack, tighten the knurled retaining
screw to fasten it securely into the rack.
Rack Slide Maintenance.
The slide-out tracks do not require lubrication. The dark
gray finish on the tracks is a permanent, lubricated coating.
Removing the Instrument.
First, loosen the front-panel knurled retaining screw.
See Figure 1--7. Grasp the front handles and pull the instrument out until all
three slide sections latch. The instrument is firmly held in this position.
To completely remove the instrument, first be sure to disconnect all cabling.
Then, press both release-latch buttons (visible in the stop-latch holes) and
carefully slide the instrument free from the tracks.