Tektronix AWG70001B, Installation And Safety Instructions

Page: 38 / 50

Connector Description
Marker outputs
AWG70001B – CH1 Markers
AWG70002B – CH1 and CH2 Markers
These SMA type connectors supply marker signals, two markers for each channel.
The marker LEDs light when the corresponding channel is enabled and the outputs are
electrically connected. Marker LEDs are always white.
USB Two USB connectors. When OFF is lighted, the front USB connectors have been disabled from
the Utilities > Preferences menu.
Removable hard disk drive (HDD) The HDD contains the operating system, product software and all user data. By removing the
HDD, user information such as setup files and waveform data is removed from the instrument.
Chassis ground Banana type ground connection.
CAUTION. Always turn off the signal outputs when you connect or disconnect cables to/from the signal output connectors. Use
the All outputs off button (either the front-panel button or the screen button) to quickly disable the Analog, Marker, and Flag
outputs. When the All outputs off is enabled, the output connectors are electrically disconnected from the instrument.
Do not connect a DUT to the front-panel signal output connectors when the instrument signal outputs are on.
Do not power on or off the DUT when the arbitrary waveform generator signal outputs are on.
Front-panel controls
The following illustration and table describe the front panel controls.
Buttons/Keys Description
Home The Home button returns the graphical interface to the home screen of the current mode (AWG or
Functions).
Play/Stop The Play button starts or stops playing the waveform.
The Play button changes to indicate the waveform play out status.
When a waveform is playing, it is only present at the output connectors if the following conditions are met.
■
The channel is enabled.
■
The All Outputs Off is not active (outputs are connected).
Operation basics
22 AWG70000B Series Installation and Safety Instructions