Tektronix AWG7000 Series, Service Manual

Page: 78 / 140

Removal and Installation Procedures
4-26
AWG7000 Series Service Manual
Power Board You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the Power board, refer to Figure 4-12 and follow these steps:
1. Remove the handle unit, snaps, cosmetic covers, front-trim unit, EMI covers,
drive- bay module, power supply, Multi-Input/Output board, and Processor
board.
2. Orient the instrument so that the bottom is on the work surface.
3. Disconnect the cables from J102, J103, J120, J300, J302, J304, J600, and J611
on the Power board.
4. Remove the 10 screws securing the Power board to the chassis.
5. Lift the board away from the chassis.
Installation. To install, reverse this procedure.
Figure 4-12: Power board removal
Power board