Tektronix AWG7 1B Series, Service Manual, Page: 75 / 174

Removal and Installation Procedures
Procedures for Internal Modules (Upper) (AWG7000C Series)
Drive-Bay Module
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal.
To remove the drive-bay module, follow these steps: (See Figure 4-9
on page 4-22.)
1. Remove the handle unit, snaps, cosmetic covers, front-trim unit, EMI covers,
and hard disk assembly.
2. Orient the instrument so that the bottom is on the work surface.
3. Remove the eight screws securing the drive-bay module to the chassis.
4. Disconnect the cables from J101 and J104 on the Power board.
5. Disconnect the cables from J5J1 and J7J1 on the Processor board.
6. Lift the drive-bay module away from the chassis.
Installation. To install, reverse this procedure.
DVD-ROM Drive You need a screwdriver with a T-15 Torx tip and a #1 Phillips screwdriver (items
1, 2, and 5).
Removal.
To remove the DVD-ROM drive, follow these steps: (See Figure 4-9
on page 4-22.)
1. Remove the handle unit, snaps, cosmetic covers, front-trim unit, EMI covers,
hard disk assembly, and drive-bay module.
2. Remove the two screws securing the DVD-ROM bracket to the drive-bay
chassis.
3. Slide the DVD-ROM drive with bracket out from the drive-bay chassis.
4. Remove the four screws securing the DVD-ROM drive to the bracket.
Installation. To install, reverse this procedure.
AWG7000B and AWG7000C Series Service Manual 4–21