Installation
Strobe Signal
You can input one strobe signal in addition to the four event signals. The strobe signal controls the timing of reading the event
signals.
When Strobe is set to Off, the instrument reads the event signals at the timing of every two internal clock cycles, and updates
the event value if a state transition in the event signals are found.
When Strobe is set to On, the instrument reads the event signals when the strobe signal goes to low state (Enable), and
updates the event value if a state transition in the event signals are found.
NOTE.
You cannot toggle the Strobe signal on and off using the screen interface or remote commands. The Strobe de
fi
nition in
the sequence
fi
le can control the strobe signal input. For more information about Strobe Signal and Sequence
fi
le, refer to
the user online help.
4
TTL Event to TekLink LVDS Connector Adapter User Manual
Summary of Contents for AWG5012B Option 09
Page 3: ......
Page 7: ......
Page 9: ...Table of Contents ii TTL Event to TekLink LVDS Connector Adapter User Manual ...
