Acquiring digital signals
Acquiring digital signals
Connect a P6316 logic probe to digital input. Connect the logic probe inputs to the DUT (see the probe instructions). Then use the
following topics to set up, acquire, and display digital signals.
•
Connect and set up digital signals
on page 81
•
Add a serial bus to the Waveform view
on page 82
•
Add a parallel bus to the Waveform view
Connect and set up digital signals
Use the digital Channel configuration menu to set up the digital channels to acquire signals.
About this task
Digital channel configuration menus are available only if a supported digital logic probe is attached to the oscilloscope.
CAUTION: To prevent damage to the instrument always wear an antistatic wrist strap when making connections to the instrument
and DUT. Always observe the maximum input voltage ratings for input connectors.
Procedure
1. Connect the logic probe to the instrument. Tap the D15-D0 . The digital signal waveforms are opened on the screen.
2. Connect the probe to the signal sources. Use the accessories in the Tektronix Probe accessory Kit (shipped with the probe) to connect
to your DUT.
3. Double-tap the D15-D0 button to open the Digital configuration menu. Set up digital channels to match your digital logic requirements.
Acquiring digital signals
3 Series Mixed Domain Oscilloscope Printable Help
81
