Specifications
TEKTON
®
FLASHLIGHT/WORKLIGHT
• Power: 3.6 VDC
• Battery Pack: Rechargeable, 3.6 VDC, 1.0 Ah, Ni-MH
• LED-Bulb Life: 100,000 Hrs.
• Dimensions: 10" L (14-1/4" extended),
2-1/2" Diameter
• Run Time: 3 hours (30 LEDs), 8 hours (6 LEDs)
• Recharge Time: 4-6 hours
• AC Charging Adapter
Input: 110-120 VAC, Output: 6 VDC, 300 mA
• DC Charging Adapter
Input: 12 VDC, Output: 12 VDC
Your new cordless rechargeable worklight is an all-purpose light designed to provide safe illumination
almost anywhere - automotive, construction, roadside emergencies, power outages, camping/tent light,
and more. Proper use and care of your worklight will help ensure a longer life and trouble-free operation.
Be sure to read and follow all instructions contained in this manual.
page 2
Initial Charging Procedure (AC Adapter Only)
Use AC charging adapter indoors in a dry location only. Exposure to damp or wet conditions
could cause electrocution or damage to adapter.
Do not use charging adapter in combination with any extension cord, electrical generators, or step-up
transformers. Always plug AC cord directly into a 110-120 V 60Hz AC outlet in a suitable location.
Normal Charging Procedure (AC Adapter)
1.) Set light on its base so it is standing vertically. Plug adapter into charging jack (Fig.2).
2.) Plug adapter into 110-120 VAC, 60 Hz outlet.
3.) Locate charging indicator LED (Fig.2). When adapter is properly plugged into charging jack and AC
outlet, indicator LED will glow red.
4.) Charge for 4 hours or until charging indicator LED glows green. To prevent overheating, do not
charge for more than 8 hours.
5.) Unplug AC adapter from electrical outlet, then disconnect from worklight.
The worklight is shipped with a minimal charge in the internal battery pack. The Initial
Charging Procedure must be completed before first use to ensure proper battery life and
performance. Failure to follow described charging procedures could permanently damage the internal
battery pack. AC and DC charging adapters are for re-charging battery only. They cannot be used to
directly power the worklight.
1.) Set light on its base so it is standing vertically. Plug adapter
into charging jack on base of worklight (see Fig.2).
2.) Plug AC adapter into 110-120 VAC, 60 Hz outlet.
3.) Locate charging indicator LED (Fig.2). When adapter is properly
plugged into charging jack and AC outlet, indicator LED will glow red.
4.) Charge unit for 8 hours. Indicator LED may glow green before
initial charge is complete. It is important to complete a full 8 hour
charge regardless of indicator LED color. To prevent
overheating, remove from charge after 8 hours.
5.) When operating for the first time, allow unit to run until battery is
discharged (light is dim or dark).
6.) The Initial Charging Procedure is now complete. To recharge unit,
refer to Normal Charging Procedure below.
AC Charging Safety Precautions
Charging the Internal Battery
AC Charging Adapter
x1
DC Charging Adapter
x1
30 LED
Worklight
Stand-Up
Magnetic Base
Charging
Indicator LED
Charging Jack
On/Off Switch
6V
6 LED Flashlight
36 LED Flashlight / Worklight
Fig.1
6V
Charging Indicator LED
Charging Jack
Worklight
Base
Fig.2
