TEKTELIC Communications T0006086, User Manual

Page: 14 / 28

Meeting Room Display Tablet User Guide T0006377_UG Version 0.5
TEKTELIC Communications Inc. Confidential Page 14 of 28

Do not discard the shipping box or inserts as they will be required if a unit is returned
for repair.
3.4 Equipment Required for Installation
The following tools are required to install the Meeting Room Display Tablet:
1) Screwdriver
2) 4x M4 Screws (Choose screw type based on mounting surface)
3) Spirit level
4) T6 Torx driver for the security/lock screw
3.5 Meeting Room Display Tablet mounting
Meeting Room Display Tablet features a removable mounting plate that simplifies the
installation and leveling of the Tablet. Once the mount plate is installed the Tablet slides onto
the four hooks on the plate. Tablet can be mounted in Landscape or Portrait
3
mode.
Note: The mounting surface must be capable of holding > 15 kg [33 lbs].
Mounting the wall plate

Thread the Ethernet and/or Power cables through the rectangular opening in the wall
plate. Ensure that the lock screw feature marked as “C” in Figure 3-1 is facing away
from the mounting surface.

Secure the mount plate on the mounting surface using 4 x M4 screws in locations A or B
as shown in the Figure 3-1.
o
Double sided adhesive tape could be used when mounting on glass

The slots provided on mount plate allows for adjustment to level the mount plate.

Using a spirit level, ensure that the mounting plate is plumb before tightening all the
screws.
Connect cables

With the externally powered version, connect the necessary cables to the Tablet
(Ethernet, 5V DC and Debug USB port are accessible under the battery cover).

No cables are required on the battery powered version.

Cables can be routed through the channels on the back of the Tablet.
3
Portrait mode is not supported in current version of firmware