LoRa IoT Smart Room Sensor User Guide
T0006338_UG
Version 1.5
TEKTELIC Communications Inc.
Page 24 of 30
4
Operation, Alarms, and Management
4.1
Configuration
The Smart Room Sensor supports a full range of Over-the-Air (OTA) configuration options.
Specific technical details are available in the Room Sensor Technical Reference Manual [2]. All
configurat
ion commands need to be sent OTA during a sensor’s downlink windows.
4.2
Default Configuration
The default configuration on the Base and External Connection Room Sensor is:
•
Report Temperature, Humidity, and Battery Voltage every one (1) hour.
•
Report actuation of the Magnetic Switch and the Digital Input (i.e. External Connector in
the digital mode) every one (1) actuation.
The default configuration on the PIR Room Sensor is:
•
Report Temperature, Humidity, and Battery Voltage every one (1) hour.
•
Report the PIR status:
o
When PIR first detects motion.
o
When PIR has stopped detecting motion for more than five (5) minutes.
•
Report actuation of the Magnetic Switch every one (1) actuation.
4.3
LED Behaviour
See Figure 1-2 for the location and identification of the sensor LEDs.
The boot and join LED procedure is as follows.
1.
Both LEDs will come on briefly when power is first applied.
2.
After a small delay (
< 1
second ) the LEDs will turn off and one of them will blink briefly.
a.
If the System LED blinks, then all health checks on the board passed.
b.
If the LoRa LED blinks, then one of the health checks failed. Consider replacing the
battery, or moving the sensor to an environment within temperature range.
3.
Immediately after the boot pattern, the join procedure will begin. During this time the
System LED will blink continuously until the sensor has joined a network.
