![TEKTELIC Communications Kona Macro Gateway User Manual Download Page 11](http://html.mh-extra.com/html/tektelic-communications/kona-macro-gateway/kona-macro-gateway_user-manual_1077282011.webp)
Kona Macro User Guide
T0005158_UG
Version 0.6
TEKTELIC Communications Inc.
Confidential
Page 11 of 32
•
Although the Kona Macro Gateway can be powered through either the direct DC input or the
power over Ethernet (PoE) input, simultaneous application of power to both inputs may result
in unexpected operation and shall be avoided.
•
The Kona Macro Gateway power source must meet SELV requirements.
•
Always ensure the 3G/4G Modem SIM card access port is properly sealed after installing a
SIM card.
2.2
Unpacking and Inspection
The following should be considered during the unpacking of a new Kona Macro Gateway.
1.
Inspect the shipping carton and report any significant damage to TEKTELIC.
2.
Unpacking should be conducted in a clean and dry location when possible.
3.
Do not discard the shipping box or foam inserts as they will be required if a unit is returned
for repair or re-configuration.
2.3
Required Equipment for Installation
The following tools are required to install the Kona Macro Gateway module:
1.
A 6 point metric socket set and torque wrench drive.
2.
Anti-oxidant compound (NO-OX-ID, Penetrox, Noalox, Ox-Gard or equivalent).
3.
A small wire brush.
4.
A clean cloth.
5.
Weatherproofing tape kit for the RF connector (Scotch Wireless Weatherproofing Kit, WK-
101 recommended).
6.
Appropriately sized pipe clamps for pole mounting or appropriate screws or bolts (four
sized M8) with any required anchors according to the wall construction for wall mounting.
2.4
Kona Macro Gateway Mounting
Kona Macro Gateway is designed to be mounted to a vertical pole or wall using the supplied
mounting bracket which attaches at the four screw locations on the back of the module
illustrated in Figure 3.