TEK-IRIGB-MNL-v2-042016
P a g e
| 7
www.tekron.com
© 2016 by Tekron International Limited. All Rights Reserved. All trademarks are the property of their respective holders. The
information in this document is provided for informational use only and is subject to change. For further information or support, go to
www.tekron.com.
5
POWERING ON THE IRIG-B ANALYZER
Pressing the Power
button will turn the IRIG-B Analyzer on. During start up, an initialization
screen with the Serial Number will be shown for a short time. Refer to Figure 8
Figure 8: Startup Screen
Once initialized, the IRIG-B Analyzer will display the Home screen as below in Figure 9
6
HOME SCREEN
Whilst in this state the unit will start searching for both fiber and copper IRIG-B inputs. Whilst
searching for a valid input signal, the analyzer will transition between different status screens
(Figure 9).
Figure 9: Sample of the displayed screens when searching for an IRIG-B signal
7
MEASURING COPPER IRIG-B SIGNALS
Warning
: The IRIG-B signals to be measured can be at a voltage level that presents a shock
hazard. Care should be taken when doing these measurements to avoid touching any
exposed terminals.
If the IRIG-B signal being measured exceeds 48V (AC or DC), then a High Voltage symbol will be
displayed at the top of the screen as in
