Rev. GSM-
РАС-v1_5_en
7)
Close the cover of the Control Panel 8945 Pro, tighten the
two screws at the bottom of the base of the Control Panel 8945
Pro.
5.3.2 Installing the module in the Control Panel 812 Pro:
1)
Turn off the power of the Control Panel 812 Pro.
2)
Open the keypad cover of the Control Panel 812 Pro.
3)
Open the cover of the terminal block by unscrewing the 2
screws securing it, remove the cover.
4)
Unscrew 4 screws from the side of the base, remove the base.
5)
Install the module into the slot of the control panel 812 Pro
PCB.
6)
Connect the GSM antenna from the delivery set to the con-
nector installed on the GSM module PCB:
7)
Insert the SIM card(s) into the module's SIM card holder
(see clause 5.3.1 step 6), SIM cards must be oriented with their
contacts to the PCB.
8)
Replace the base, tighten the 4 screws.
9)
Close the cover of the Control Panel 812 Pro terminal block,
tighten the two screws securing it. Close the keypad cover if
necessary.
6 SETUP
Module configuration is carried out using a computer and the
PKM program Astra-Pro according to the method described in
the User's Manual of the software.
When using the module as part of the Astra-812 Pro control
panel, it is possible to add and configure it through the built-in
keypad and display of the Astra-812 Pro control panel according
to the instructions for the Astra-812 Pro control panel.
7 WARRANTY
7.1 Warranty period of operation - 2 years from the date of
commissioning, but not more than 2 years 6 months from the
date of manufacture.
7.2 Average module life is 10 years.
7.3
The warranty does not take effect in the following cas-
es
:
–
non-observance of this user guide;
–
mechanical damage to the module;
–
module repair by a person other than the manufacturer.
9.4 The warranty only applies to the module. All third party
equipment used with the module is covered by their own war-
ranties.
The manufacturer is not liable for any damage to health,
property, or other incidental or special loss, direct or indi-
rect damages based on the user's claim that the module
did not fulfill its functions, or as a result of misuse,
failure
or temporary inoperability of the module.
Manufacturer:
ZAO NTC TEKO
420108, Russia, Kazan,
Gafuri str., 71
Tel.:+7 843 528-03-69
Made in Russia