Teknoware TKT6716C, Installation And Maintenance Instructions Manual

Page: 39 / 56

VOT 2; Rev 1.2; EN; 09.07.2013
TKT67C
– Installation and maintenance
39
The condition of the fuses is monitored in real-time on mains operation. Blown fuses can be detected if
there is any load on the circuit. Empty circuits are not inspected.
NOTE! Only maintained circuits can be monitored in real-time (MODE closed). An internal error alarm
on a fuse error will be given as soon as the error is detected. The error information will be automatically
reset when the fuse has been replaced with a new one.
The condition of the output circuits is checked only before the tests. The circuit voltages are checked at
this time with an open and closed output circuit. Empty circuits are not inspected in this case either. An
output circuit error results in an internal error alarm.
In circuit monitoring the LEDs of the front panel and in the report the corresponding circles show the
strength of the current of the circuit. The stronger the current of the circuit, the higher the LED column.
The LED column grows higher starting from down to upwards.
APPENDIX 2: Mechanical dimensions