Teknoware TKT6716C, Installation And Maintenance Instructions Manual

Page: 15 / 56

VOT 2; Rev 1.2; EN; 09.07.2013
TKT67C
– Installation and maintenance
15
4.9 Control Module panel luminaire
monitoring LED’s and menu settings
LED Description Instruction
Number display
Shows the number of the circuit whose
luminaires are shown with LEDs 1-16.
If “CC” is flashing on the display, the system
has not been configured.
For configuring the system, see
chapter
5.3.4 Configuration.
LEDs 1-16
There are two meanings of these leds:
1. To show information of the luminaires.

How many luminaires installed and
address of the luminaires.

Status of the luminaires.
2. To indicate selection in menu

Instructions how to check and change
settings from menu are below.
Addressable monitoring:
The LEDs display the status of
luminaires in the aforementioned
circuit.

If the LED is continuously lit, the
luminaire is functional.

If the LED is flashing, the
luminaire is faulty.

!f the LED is not lit, no luminaire
has been assigned for that
address.
Circuit monitoring:
The LED bars display the total input
power of the circuit.
If the LED or LEDs are flashing during
circuit monitoring, an error has been
detected in the circuit.
See the instructions given for
corresponding LEDs.
1 REPORT
Use this option to print out report of the
configuration of the central battery unit and the
status of the luminaires.
Value 1 = Print a report of all circuits.
Value 2 = Print a report of faulty circuits.
Value 9 = Displays circuit board + circuit
number on the display instead of a running
number
NOTE: This action requires a printer, which is
an optional feature TST6731 or the central
battery units of the type Tapsa Control
TKT67xxC(N)D(L).
To print a report,
1. Go to the menu with the
MENU / OK button.
The REPORT LED is lit.
2. Press the SET button once.
Number 1 will appear in the display.
3. Acknowledge by pressing the
MENU / OK button again.
Printing of the report will start.
NOTE: Printing of the reports is
blocked during the tests.