![Teknor Industrial Computers TEK-AT2 Hardware Reference Manual Download Page 4](http://html1.mh-extra.com/html/teknor-industrial-computers/tek-at2/tek-at2_hardware-reference-manual_1077043004.webp)
CONFIGURATION
SECTION 2
JUMPERS
The TEK-AT2 was designed to allow for minimal
hardware configuration.
The following Jumpers can be configured by using
shorting jumpers.
JUMPER
1
STATE
FUNCTION
* as shipped
Flash EPROM Type
W1(1-2)
29F040 Devices Only
2
W1(2-3)
28F010, 28F020 Devices Only*
RAM Battery Backup
3
W2
Open*
NC
W2
Closed
Vbatt
Hard Disk Interface
W3
Open*
IDE Enabled
W3
Closed
IDE Disabled
Watchdog Timer
W4
Open
Disable
W4
Closed*
Enable
1
W2A is not used. Do not install shorting jumpers.
2
Devices expected to be available 4Q93
3
Vbatt must be installed to save configuration information
at power down.