Tekno SMIV series, Installation Manual

Page: 36 / 56

Operation of wireless remote control
Sketch map for
changing batteries
Changing batteries and notices
About lock
Press +and - buttons simultaneously to lock or unlock the keyboard. If the remote controller is
locked, the icon will be displayed on it, in which case, press any button, the mark will flicker
for three times. If the keyboard is unlocked, the mark will disappear.
About swing up and down
1. Press swing up and down button continuously more than 2s,the main unit will swing back
and forth form up to down, and then loosen the buttothe unit will stopswinging and present position
of guide louver will be kept immediately.
2. Under swing up and down mode, when the status is switched from off to , if press this
button again 2s later, status will switch to off status directly; if press this button again within
2s,the change of swingstatuswill also depend on the circulation sequence stated above.
About switch between Fahrenheit and Centigrade
Under status of unit off, press +and - buttons simultaneously to switch.
About new function of defrosting
It indicates: after starting this function by remote controller and the unit has been underdefrost
status, If turn off the unit by remote controller, the unit will not stop defrosting until it is finished;
if change setting mode by remote controller, the function ,which is set last time,won't be carried
out until defrosting finished.
Operation of this function on or off: If remote controller is under off status, press mode button
and blow button simultaneously in order to enter or cancel this new function. If the unit is under
defrost mode,dualeight position on remote controller will display H1.If switch to heat mode, the
position will display H1, which flickers for 5s, in which case, press +/- button, H1 will disappear
and setting temp. be displayed.
After remote controller is powered on, the new defrost function will be defaulted to be closed.
1. Slightly to press the place with , along the arrowhead direc-
tion to push the back cover of wireless remotecontrol. (As show
in figure)
2. Take out the old batteries. (As show in figure)
3. Insert two new AAA 1.5V dry batteries, and pay attention to
the polarity. (As show in figure)
4. Attach the back cover of wireless remote control. (As show in
figure)
NOTE:
When changing the batteries, do not use the old or different
batteries,If the wireless remote control will not be used for a long
time, please otherwise, it can cause the malfunction of the wire-
less remote control.take them out, and don't let the leakage
liquid damage the wireless remote control.
The operation should be in its receiving range.It should be
placed at where is 1m away from the TV set or stereo sound
sets.If the wireless remote control cannot operate normally,
please take them out, a fter 30s later and reinsert, if they cannot
normally run, please change them.
36