Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
dH=1.25 Clarke=1.78 fH=0.178mmol/l
°
°
°
1
The manufactory setting: H4
Contact your local water board for information on the hardness of your water supply.
6
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 55
German
dH
German
dH
Salt consumption
(gram/cycle)
Salt consumption
(gram/cycle)
0 - 9
10 - 20
21 - 30
31 - 40
41 - 60
61 - 98
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
H1->
Light bright
H2-> 90 min Light bright
H3-> 90 min, Rapid Light bright
H4-> ECO Light bright
H5-> ECO, Rapid Light bright
H6-> ECO, 90 min Light bright
Rapid
0
9
12
20
30
60
French
fH
French
fH
Mmol/l
Mmol/l
Water softener level
Water softener level
British
Clarke
British
Clarke
WATER HARDNESS
1.
Open the door and switch on the appliance
2.
Press the Program button for more than 5 seconds, when the salt indicator
flashes means entering the water softener settings.
set model within 60 seconds after the appliance was switched on.
3.
Press the Program button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6.
4.
Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
.
