Teknika MUL-350 Adjustment Instructions Download Page 1

Adjustment instructions for MUL-350/351 

 

1.

 

Adjustment for seal height.  
 

Proper slot for a seal is achieved when the seal can be inserted in the slot with ease, but sits 
tightly in the slot. NOTE: if the seal is loose in the slot, the joint might not close properly. 

 

1.1.

 

Hold 350-63 SET SCREW 4x20 in place by using T-Key 2mm and loosen 350-60 
NUT M4 using Wrench 7mm (Fig. 1a).   

 

1.2

 

 Hold 350-60 NUT M4 in place and make an adjustment by turning T-Key 2mm 
(Fig. 1b).      

 

Clockwise rotation will lower the slot for a seal. 

 

Counter-clockwise rotation will raise the slot for a seal. 
 

1.3

 

Once required height is achieved, hold T-Key 2mm in place and tighten 350-60 NUT 
M4 (Fig. 1с).  
  

2.

 

Adjustment for strap thickness.  
 

Factory setting for strap thickness is 0.035” (0.9mm). MUL-350/351 can be adjusted to 
work on strap up to 0.040” (1mm).  
 

2.1.

 

Using T-Key 5mm loosen 350-67 SCREW M6x12   (Fig. 2a). 
 

2.2.

 

Turn 350-57 ADJUSTMENT PLATE to adjust for required strap thickness (Fig. 
2b). 15° turn is roughly equivalent of 0.004”(0.1mm) adjustment in strap thickness. 

 

Clockwise rotation will adjust for thinner strap. 

 

Counter-clockwise rotation will adjust for thicker strap. 

Reviews: