Step 16
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the TRAY BACK (J) and TRAY FRONT (K). Use eight SILVER 1/2" FLAT
HEAD SCREWS (18).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the TRAY FRONT/TRAY BACK.
Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used in the next step.
1
1
1
1
Open end
Page 20
K
J
SILVER 1/2" FLAT HEAD SCREW
(8 used for the RAILS)
18
Open end
Open end
Push up on the black lever and pull the SLIDE from the RAIL.
2
1
