å
We have provided a Nail Holder tool to use in this step for proper positioning of the NAILS. Please refer to the parts of the
Nail Holder as the bead, offset edge, and nail slot as shown in the diagram below.
å
Diagram 1. Place the BACK (O) into the lower edge of the RIGHT END (A) with the top edge of the BACK (O) against the
lower edge of the TOP (P).
å
Diagram 2. Place the bead of the Nail Holder down between the BACK (O) and LEFT END (B) 2-1/2" from the corner.
Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into lower edge of the LEFT
END. Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the BACK
to the LEFT END with the hammer and Nail Holder placing NAILS approximately 3-3/4" apart.
å
Repeat this step to fasten the BACK (O) to the RIGHT END (A).
å
Diagram 3. Fasten the BACK (O) to the TOP (P) using the NAILS (1N) and Nail Holder. The NAILS should be 1-1/2" from the
corners and 4-3/4" apart.
Step 11
NAIL
(21 used in this step)
1N
Unfinished
surface
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
P
B
O
A
For support, place packing
foam and magazines here.
2-1/2"
2.
Page 16
Bead
Nail slot
Nail
Holder
Offset edge
L
N
N
1.
3-3/4"
Bead
Bead
3.
4-3/4"
1-1/2"
Lower edge
Bead
Bead
