- -
11
Brief introduction
1.
Make sure the computer installs Tekmand On PC 3.3.0.12 before operation.
2.
3.
Connect the computer to the fader wing via USB cable. Use Zadig to install the
driver.
Open the Tekmand On PC software, press “SETUP” and a dialogue will pop up
which shows the connection is successful.
4 LED backlit brightness: Keep all faders
in a
programme, and then push these faders to the top. Enter SETUP/Controller/Lighting
operation interface, scroll up/down “EXECUTOR LED ”bar to adjust the brightness
from 0% to 100%.
5 Fader: Enter SETUP/Controller/Hardware Detect operation interface, push the
fader and the value will be the same as the percentage in the fader bar shown in Pic
two.
6.LED light full off : Enter SETUP/Controller/Hardware Detect operation interface,
click “control all LED” , all LED should be full on/off.
Pic One
.
.
on the
lower middle keyboard