Teka NF1 650, Instruction Manual

Page: 11 / 34

Installation Requirements
In order to operate the automatic ice
maker/dispenser and chilled water dispenser,
your appliance needs to be plumbed into the
cold mains water supply in your house via a
standard 1/2 “ valve fitting. In case this valve
is not present or in case you are not sure,
consult a qualified plumber.
* First of all, make sure that the parts on the
side are shipped with the device.
1.
5-meter long water pipe (1/4 inch in
diameter)
2.
Cold mains water valve with mesh filter
(Tap Adapter)
3.
3 pieces of pipe clips (In case required to
secure the water pipe)
4.
Water Filter to be fitted to the bracket
inside the fridge compartment.
5.
Nut for connection of the water pipe to the
rear of the appliance
10
Please follow the instructions below.
MAKE SURE THAT STANDARD 1/2”
VALVE FITTING FED BY COLD MAINS
WATER SUPPLY IS AVAILABLE AND
IS TURNED OFF FULLY.
Connection of the Water Pipe to the
Refrigerator
1.
After assembling the nut on the water
pipe, insert the water pipe to the refrigerator
inlet valve by pressing downwards firmly.
2.
Fix nut as seen in the opposite figure, by
squeezing by hand on the refrigerator inlet
valve.
Note:
You should not need to tighten the
nut with a tool to achieve water tight
assembly. In case of a leak use a spanner
or a pair of pliers to tighten the nut.
1
5
2
3
4
Connection to the Cold Mains
Valve
Water Tube
Water Tube
Nut
1
2
EN