Teka E1 EX 90.1 6G AI AL DR CI, Instruction Manual

Page: 22 / 68

22
INSTALLATION
TECHNICAL INFORMATION
FOR THE INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
The appliance must be correctly installed in
conformity with current law and the
manufacturer's instructions.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or by
his duly authorized dealer.
5) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children’s reach since they could become
potential sources of danger.
The measurements of the opening made in the top of
the modular cabinet and into which the cooktop will be
installed are indicated in either fig. 7. Always comply
with the measurements given for the hole into which
the appliance will be recessed (see fig.7 and minimun
distance for fig. 8).
The prospective walls (left or right) that exceed the
working table in height must be at a minimum
distance from the cutting as mentionned both in
the columns “E” of the scheme.
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
6) FIXING THE HOT PLATE
The cooktop has a special putty which prevents
liquid from infiltrating into the cabinet. Strictly
comply with the following instructions in order to
correctly apply this putty:
- take off all the movable parts of the hob.
- Detach the putty from their backing, checking
that the transparent protection still adheres to the
putty itself.
- Overturn the cooktop and correctly position putty
“E” (fig. 9) under the edge of the cooktop itself,
so that the outer side of the putty perfectly
matches the outer perimetral edge of the
cooktop. The ends of the strips must fit together
without overlapping.
- Evenly and securely fix the putty to the cooktop,
pressing into place with the fingers and remove
the strip of protective paper from the putty and
set the plate into the hole made in the cabinet.
- Carefully trim the edge excess putty with a tool
(fig. 9/A - 9/B).
- Fix the hob with the proper brackets “S” and fit
the prominent part into the porthole “H” on the
bottom; turn the screw “F” until the bracket “S”
stick on the top (fig. 10).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the
working, is necessary to put a wooden insert,
fixed by screws, at a minimum distance of 70
mm from the top (see fig. 7).
IMPORTANT:
a perfect installation, adjustment or
transformation of the cook top to use other
gases requires a QUALIFIED INSTALLER: a
failure to follow this rule will void the
warranty.
Keep the Warranty Certificate or the sheet of technical
data with the Instructions Handbook during the
appliance life. It contains important technical data.