4
2.Quick user guide
For detailed operating method read the corresponding content on the instruction manual.
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
T
,close the door
machine will start working at once.
urn on the water tap
. The
Running the dishwasher
Switch off the appliance
T
unload the baskets
urn off the water tap,
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more susceptible to break.
The dishes will also dry better. First start unloading the lower basked.
Changing the programme
Adding forgotten dishes
in the dishwasher.
To load the baskets, refer to the section entitled
Loading the Dishwasher Baskets
.
“
”
Touch
( See the section entitled
“
Operation instruction
”
)
the Programme Button until the selected programme lights up.
If the appliance is switched
off during a wash cycle.
Open the door carefully.
Look out for hot steam
when opening the door!
WARNING!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance
Open the door,
touch
the On/Off button to switch on the appliance .
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again .
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2.Open the door.
3. T
ouch
the
Programme Button
for more than 3 seconds to cancel the running programme.
4. Select a new programme.
5. Restart the dishwasher.
When the working cycle has finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
Since the appliance is standing by, it will power off automaticly after 30 minutes without any operation.
Open the flap(marked with A), fill in the main wash detergent , and then close the flap;
Pre wash detergent drop into the tank directly;
(Follow the user instructions!)
Check the rinse aid level
Refill the rinse aid through the hole below the cap(marked with B)
If you need .
Fill the detergent dispenser
A
B