Teka DAL-90, Instruction Manual

Page: 4 / 12

ENG
TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as
it deems necessary, without altering their basic characteristics.
Clean the filters when the saturation indicator
lights up. (See page 12, Filter cleaning
section).
Once you have cleaned the filters, and with
the hood turned off, press the “Filter
Saturation RESET” button for 3 seconds and
the indicator will switch itself off.
During cleaning and maintenance work,
make sure the safety instructions set out
on page 10 are complied with.
• If your kitchen hood is made from stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• The use of vapour cleaners is not
recommended.
Extract the filters from their housings using the
handles specially designed for this purpose.
The metal filters can be cleaned by soaking them in
hot water with neutral detergent until the fat
dissolves and then rinsing them under the tap or
using special anti-grease products. They can also
be washed in a dishwasher. In this case, it is
advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic
surface (blackening it), although this will not affect
its fat retention capacity.
Once clean, leave them to dry off and then fit them
onto the kitchen hood.
Fig. 2 (Page 31)
Proceed as follows:
• Remove the metal filters. Loosen the screws
(without unscrewing them) of the EASYCLEAN
panels (A19), move the panels aside carefully
and take them off.
• Dismount the support (C) by loosening the
screws (B).
• Change the broken/ burnt out lamp (D).
Maximum lamp power is 20 W (G-4).
• Mount the support again (C).
• Mount the EASYCLEAN panels again (A19). Fit
the metal filters.
Cleaning the metal filters
Cleaning the hood body
Cleaning and maintenance
_________________________________________________________
Problem solving
Proceed with the following checks before calling the Technical Service:
Changing light bulbs
Sizes and specifications
See page 30.
Filter saturation indicators “F”
12