Tegam 138-415-1, Instruction Manual

Page: 9 / 59

Operation & Service Manual Section I
Model 1805B RF Control Unit Introduction and General Description
Manual Title
IM128
Models 1109, 1109H and 1110 Coaxial Power Standards, Operation
and Service Manual
IM198
System IIA, Automatic Power Meter/Sensor Calibration System,
Opertion and Service Manual
IM199
Model 1807A RF Transfer Standard, Operation and Service Manual
IM205
Models 1111 and 1116 Coaxial Power Standards, Operation
and Service Manual
IM241
Models 1119, 1119H and 1120 Coaxial Power Standards, Operation
and Service Manual
IM245
Models 1117A, 1117A and 1118 Coaxial Power Standards, Operation
and Service Manual
IM249
Operation Manual, SWR Measurement Kit (P/N 187-4003)
IM255
Operation Manual, 50-75 W Minimum Loss Matching Pad (P/N 138-
650)
IM267
Model 1727A, Amplifier, Operation and Service Manual
CONTACTING TEGAM
In the event of an instrument malfunction, contact TEGAM. An apparent malfunction of
an instrument or component may be corrected over the phone by contacting TEGAM.
DO NOT send the instrument or component back to the factory without prior authoriza-
tion. When it is necessary to return an item, state the symptoms or problems, catalog
and type number of the instrument or component, serial number of the item, and date of
original purchase. Also write the company name, your name, and phone number on an
index card. Then attach the card to the instrument or component to be returned. Or
contact TEGAM using the following:
TEGAM, INC. 800-666-1010 toll-free
TEN TEGAM WAY 440-466-6100 phone
GENEVA, OH 44041 USA 440-466-6110 fax
ELECTROSTATIC DISCHARGE SENSITIVE
The equipment documented in this manual contains certain Electrostatic Discharge
Sensitive (ESDS) components or parts. Therefore, certain procedures/steps are
identified by the use of the symbol . This symbol is used in two ways:
!
CAUTION
All procedures and/or steps identified as must be followed exactly as written and
according to ESDS device handling procedures. Failure to comply WILL RESULT IN
ESDS damage.
a. When the ESDS symbo l is placed between a paragraph number and
title, all of that paragraph, including all subparagraphs, is considered an
ESDS device handling procedure.
b. When the ESDS symbol is placed between a procedure/step number
and the text, all of that procedure is considered an ESDS device handling
procedure.
1-2