Tefcold ODC60-90, User And Maintenance Manual

Page: 17 / 39

17

COMPOSITION OF THERMAL INSULATION
The thermal insulation is made from expanded polyurethane 40 kg/m
3
, with expansive agent C4H5F5.
5. START-UP

FIRST CLEANNING
Clean the unit before connecting to the electricity supply.

INSPECTION

Check that the voltage and power line frequency coincide with those indicated on the specification plate of the appliance.

The unit should not be used in threatening atmospheric or fire risk conditions.

Check that there are no defects on the unit resulting from its transportation. The manufacturer will not be liable for damage
suffered during transportation or arising from incorrect storage.

Check the operation of the moving components of the unit.

Check the safety of the control board, electrical cables and connections.

Check that all the interior and additional accessories are present.

GENERAL CONNECTIONS

Be sure the power cable is not damaged.

If the power cable is damaged it must be replaced by another type H05-VV-F or H05-VVH2-F. This repair must be
performed by qualified personnel.

It is essential that the electrical installation to which the unit is going to be connected has an EARTH LEAD , as well as the
necessary thermal and differential magnetic protection.

The power supply must have the suitable section for the consumption of the appliance.

If various units are installed in a row, each one must be connected independently to the power supply, avoiding the use of
extension leads or multiple plugs.

The manufacture disclaims all liability in the event that any of the above points are not followed.

OPERATING ELEMENTS AND INDICATORS
TURN ON/ OFF
Press until appear ON to turn on the unit.
To turn off the computer press the button for 5 sec until appear OFF and the condensing unit will stop working.
Check set point
Press
“set” 1 sec and the set point or set point will appear. Release key.
Up the set point

One the inside of the unit is clean, connect the power supply and
place the switch in the
I/ON
position. The switch should be lit
up.The thermostat display shows the air temperature inside the
unit.

Three minutes after turning on the switch, the LED showing the
compressor is working will light up permanently.

The initial temperature that is shown on the thermostat display
will be the ambient temperature. As the machine works, the
temperature will reduce until it reaches its operating temperature.
COMPRESSOR THERMOSTAT
FAN
GÉNÉRAL SWITCH