TEFAL KI710D70, Manual

Page: 13 / 24

13
EN
• Descale regularly, preferably at least once a month or more frequently if your water is very hard.
Temperature detection in the kettle may be affected by limescale.
To descale your kettle.
• Using white vinegar which can be bought from hardware stores:
– Fill the kettle with 2 cups (0.5 L) of white vinegar,
– Leave to stand for 1 hour without heating.
• Using citric acid:
– Boil 2 cups (0.5 L) of water,
– Add 1 3/4 tablespoons (0.88 ounces) of citric acid and leave to stand for 15 min.
• Empty your kettle and rinse 5 or 6 times. Repeat if necessary.
To descale your filter.
• Soak the filter in white vinegar or diluted citric acid.
• Never use a de-scaling method other than what is recommended above.
DESCALING
IN THE EVENT OF PROBLEMS
quickly (10 to 15 uses). It is important to clean it regularly. If it is wet, put it under a running
tap, if dry, then brush it gently. Sometimes the lime scale will not detach itself; it will then need
descaling.
THERE IS NO EVIDENT DAMAGE TO YOUR KETTLE
• The kettle does not work
– Check if the kettle is properly connected.
– The kettle has been switched on without water or an accumulation of scale has caused the
overheat cut-out to operate: allow the kettle to cool and fill it with water. Descale first if scale
has accumulated.
• Switch it on: the kettle should start working again after about 15 minutes.
IF YOUR KETTLE HAS BEEN DROPPED, IF IT LEAKS OR IF THERE IS VISIBLE DAMAGE TO THE
POWER CORD, THE PLUG OR THE BASE OF THE KETTLE.
• Return your kettle to your After-Sales Service Center, only they are authorised to carry out repairs.
See the warranty conditions and list of centers in the booklet supplied with your kettle. The type
and serial number are shown on the bottom of your kettle. This warranty covers manufacturing
defects and domestic use only. Any breakage or damage resulting from failure to comply with
the instructions for use is not covered by the warranty.
• The manufacturer reserves the right to modify the characteristics or components of its kettles at
any time in the interests of the consumer.
• Do not use the kettle. No attempt must be made to dismantle the kettle or its safety devices.
• If the supply cord is damaged, it must be replaced by the manufacturer, its after-sales service
center or a similarly qualified person, in order to avoid any danger.