TEFAL Infusa BJ800DKR, Manual

Page: 10 / 35

10
USE
1. Set the base on a flat, stable and heat-resistant surface that is not
exposed to splashes of water or any heat source.
2. Opening the lid
• Grasp the teapot handle and remove the lid with the basket (diagram
2/3) . Do not operate the tea maker without its lid. If the lid is lost or
broken, please contact your After-Sales service centre.
• The tea maker must only be used with the base provided.
3. Fill the teapot with the desired quantity of water (diagram 4)
• Never fill the teapot when it is sitting on its base.
• Do not fill it above the maximum level, or below the minimum level. If
it is not filled to the minimum level, temperature accuracy cannot be
reached (temperature ac/- 3°C).
• If the teapot is too full, boiling water may spill out. Do not operate the
tea maker without water. Check that the lid is properly closed before
use.
• Do not put the infuser basket back in the teapot.
4. Set the teapot on its base and REPLACE THE LID (diagram 5).
Connect the tea maker power cable.
• the base will light up and indicate the water temperature in real time.
(diagram 5+ zoom)
5. Starting the tea maker
A. Temperature selection
– Press the temperature selection button (diagram 6) , select the
temperature: 40°C, 50°C, 60°C, 70°C, 80°C, 85°C, 90°C or 100°C.
– The temperature selection indicator light flashes 4 times and beeps,
and heating begins (diagram 7) .
– Note: It is possible to start the cycle before the automatic start by
pressing the on/off button.
– When the required temperature is reached, the tea maker stops and
beeps twice (diagram 8).
B. Tea infusion
– Without removing the teapot from its base, remove the lid from the
infuser basket (diagram 9)
– Fill the infuser basket with the desired quantity of tea leave or tea
bag(s) (diagram 10)
– Replace the infuser basket in the teapot, taking care not to burn
yourself by touching the lid (diagram 11).