EN
Owner’s manual
12
1. Cross the two parts of cross base so that the cut-outs slide into each
other and secure with the screws.
2. Remove the Height adjustment knob from the Height adjustment pipe
by turning it counterclockwise.
3. Slide the cover down to the cross base so that the connections are
covered and place the knob back in place.
4. Slide out the height adjustment pipe to the set the desired length and
secure it in place using height adjustment knob.
5. Remove the bolt from the bottom of the motor unit holder then place
the unit on the inner pipe and place the bolt
back in place to secure it.
6. Fix the rear guard on the motor housing with
rear guard screw.
7. Screw down the blade onto the fan axle with
blade screw.
8. Fasten the front guard and rear guard with the clamp.
OPERATION
MOUNTING
Note: Make sure the product is fully assembled before plugging it into
power supply socket.
1. Place the fan on a flat stable surface.
2. Make sure the timer knob is set to OFF position.
3. Plug the fan into power mains.
4. Set the timer knob to ON position.
5. Press one of the speed buttons to control air outlet: 1 - low, 2 - medium,
3 - high. Press 0 button to turn the fan off.
6. Set timer using the timer knob (up to 2 h).
7. To control oscillation press/pull the oscillation button.
8. To adjust the tilt angle, grab and tilt the motor housing up or down to
the desired angle.
9. When you want to adjust the height of the fan you can loosen the height
adjustment knob and adjust the pipe to the desired height and then
fasten it.
Clamp
