Model 4RJ45
7
Teel Operating Instructions and Parts Manual
®
E
N
G
L
I
S
H
Symptom
Possible Cause(s)
Corrective Action
SYSTEM (Continued)
Engine heats
1. Obstruction in suction piping
1. Locate and remove obstruction. Attach strainer
excessively
2. Discharge head too low
2. Decrease rate of flow
Abnormal noise
1. Obstruction in suction piping
1. Locate and remove obstruction. Attach strainer
and/or vibration
2. Suction lift too high
2. Check with gauge or measure vertical distance
between water surface and center line of pump,
allowing for friction loss in suction pipe. Reduce
rate of flow to obtain desired lift. Refer to pump
performance chart
3. Discharge head too low
3. Decrease rate of flow
Pump works for a
1. Suction lift too high
1. Check with gauge or measure vertical distance
while then stops
between water surface and center line of pump,
allowing for friction loss in suction pipe. Reduce
rate of flow to obtain desired lift. Refer to pump
performance chart
2. Suction inlet not immersed
2. Refer to Installation
deep enough
3. Leaky suction line or connection
3. Repair or replace suction line. Tighten connections
admitting air
Troubleshooting Chart
Limited Warranty
DAYTON ONE-YEAR LIMITED WARRANTY.
Teel
®
engine driven high pressure centrifugal pump, Model covered in this manual, is
warranted by Dayton Electric Mfg. Co. (Dayton) to the original user against defects in workmanship or materials under normal use for one
year after date of purchase. Any part which is determined to be defective in material or workmanship and returned to an authorized service
location, as Dayton designates, shipping costs prepaid, will be, as the exclusive remedy, repaired or replaced at Dayton’s option. For limited
warranty claim procedures, see PROMPT DISPOSITION below. This limited warranty gives purchasers specific legal rights which vary from
jurisdiction to jurisdiction.
LIMITATION OF LIABILITY.
To the extent allowable under applicable law, Dayton’s liability for consequential and incidental damages is
expressly disclaimed. Dayton’s liability in all events is limited to and shall not exceed the purchase price paid.
WARRANTY DISCLAIMER.
Dayton has made a diligent effort to provide product information and illustrate the products in this literature
accurately; however, such information and illustrations are for the sole purpose of identification, and do not express or imply a warranty
that the products are MERCHANTABLE, or FIT FOR A PARTICULAR PURPOSE, or that the products will necessarily conform to the illustrations
or descriptions.
Except as provided below, no warranty or affirmation of fact, expressed or implied, other than as stated in the “LIMITED WARRANTY”
above is made or authorized by Dayton.
PRODUCT SUITABILITY.
Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of products
for certain purposes, which may vary from those in neighboring areas. While Dayton attempts to assure that its products comply with such
codes, it cannot guarantee compliance, and cannot be responsible for how the product is installed or used. Before purchase and use of a
product, review the product applications, and all applicable national and local codes and regulations, and be sure that the product,
installation, and use will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to you; (b) also, some jurisdictions do not allow a
limitation on how long an implied warranty lasts, consequently the above limitation may not apply to you; and (c) by law, during the period
of this Limited Warranty, any implied warranties of implied merchantability or fitness for a particular purpose applicable to consumer
products purchased by consumers, may not be excluded or otherwise disclaimed.
PROMPT DISPOSITION.
Dayton will make a good faith effort for prompt correction or other adjustment with respect to any product which
proves to be defective within limited warranty. For any product believed to be defective within limited warranty, first write or call dealer
from whom the product was purchased. Dealer will give additional directions. If unable to resolve satisfactorily, write to Dayton at address
below, giving dealer’s name, address, date, and number of dealer’s invoice, and describing the nature of the defect. Title and risk of loss
pass to buyer on delivery to common carrier. If product was damaged in transit to you, file claim with carrier.
Manufactured for Dayton Electric Mfg. Co., 5959 W. Howard St., Niles, Illinois 60714 U.S.A.
