TeeJet SmartPad II, User Manual

Page: 163 / 198

SmartPad II
Software Version 4.02
Chapter 4 - Waypoint Navigation 4-33
Nav 2 Point Real-Time Scenarios
Navigating to Points
In this example the operator will be displaying a Point/Grid file that contains a set of points the operator wants to nav-
igate to. The Data Setup menu, Figure 4 -39, shows how the operator has configured Nav 2 Point. Because the Point/
Grid file exists the operator only need to select Show. As in the previous example, the operator also wants to offset the
antenna to position it over the soil probe located on the back of the pick-up truck, see Figure 4 -40.
Once the setup process is completed and the operator has selected Start Nav 2 Point they will be presented with the
Start Nav 2 Point page shown in Figure 4 -41 and Figure 4 -42. In this example the operator will need to select the
existing Point/Grid file and the existing Boundary file. Lastly the operator will need to enter the starting sample point
number, Figure 4 -43. After the operator has selected the appropriate file names and entered the starting sample point
number, they will select and press the GO menu item, this will bring them to the real-time view page, Figure 4 -44.
Figure 4-39: Data Setup Menu
Figure 4-40: Setting Up an Antenna Offset