frequencies. you can easily tune into your desired stations from those preferred
frequencies.
1. Press the [ETM] button with [ETM] shows on screen to
enter Easy Tuning Mode.
2. Press & hold the [ETM] button until the frequency start
running to auto scan and store stations into ETM memory,
within the present band.
3. When the frequency stop running, turn around the
[TUNING] knob to select those stored stations.
Notes:
While operating ETM to search for stations, a few stations might be missed if
there is interference in the surrounding. In this case, you can simply key-in the frequency,
then press the [ETM] button to manually store it into ETM memory.
Tips:
FM station:
When you are in a different city or country, you should perform the ETM
function again in stead of using ATS function, because this will not delete any of the
stations already stored within the memory.
MW station:
It is recommendable to perform the ETM function during night time, because
there are usually many stations starting broadcasting at night.
SW station:
It is recommendable to perform the ETM function in the morning, afternoon
as well as night time, because the transmitting signal of SW is very unstable and usually
there are more stations that start broadcasting in the late afternoon.
METHOD 2: MANUAL TUNING
Frequency searching:
Press the [VF] button to switch into frequency mode, and
then rotate the [TUNING] knob to select your desired station.
FAST/SLOW tuning is shown in the chart below for each band.
Slow tuning mode
Fast tuning mode
Step
Band
Turning step
Turning step
FM 0.01MHz
0.1MHz
MW 1kHz
9/10kHz
LW 1kHz
9kHz
SW 1kHz
5kHz
Memory searching:
Press the [VM] button to switch into memory mode, and then rotate
the [TUNING] knob to select those stored stations.
METHOD 3: AUTO BROWSE STATION
1.Turn on the radio and press the [VF] button to switch into
frequency mode.
