Method 3:
Direct frequency entry
Use the numeric keypad to enter the frequency directly.
Note:
No need to enter decimal point for FM Band when input the frequency numbers.
For example, FM 89.0 MHz, Just ENTER 8 9 0 .
Method 4:
Manual memory search (see page 12)
Method 5
: Auto-scan memory (see page 12)
Method 6:
Direct memory access (see page 12)
TO STORE STATION
There are total 500 preset memories within PL-310. For FM, MW, and LW, each band has
100 preset memories; and 200 preset memories for SW.
ATS (Auto Tuning Storage) on FM, MW, LW or SW band
1. Turn on the radio, and fully extend the antenna.
2. Short press [FM] button to select FM band.
3. Long press on [FM] button with a "B" sound and frequency is running on the display. All
the available stations will be stored in the memory automatically. It will stop when it is
done.
4. Then use the [TUNING] knob to tune around for those stored stations.
MW, LW or SW ATS is same as the FM ATS.
Special note:
There are mode A & mode B during applying ATS in SW.
Mode A : Auto-searching & storing all the radio stations within all meter bands.
Mode B: Auto-searching & storing all the radio stations within present meter band.
Special note:
1. During the processing ATS with mode A in FM / MW / LW & SW, pre-stored radio
stations would be deleted & covered automatically by the new searched & stored stations.
If ATS is interrupted or being turned off, radio stations without deleted & covered by ATS
would still be kept.
With ATS mode B in SW, it will not delete & cover all existing memories; all the newly
found radio stations would be stored in the blank memories addresses.
2. If there is interference found in surroundings area and ATS is not function properly,
lower down the telescopic antenna to restart the ATS again. (For Turning the radio
body around to other directions in order to receive better frequency in MW / LW).
