Reference Manual Rev 3.23
Software Versions 3.xx
Page 53
11. Special Functions
11.1. Introduction
The instrument has a special function key on the front panel. This
function of this key can be configured to any of the key functions detailed
below. Refer to KEY.FN (Key Functions) page 35 to configure the
function key.
When leaving the factory, the <FUNCTION> key is blank and has no primary
function pre-programmed. Each primary function has an associated overlay sticker
(supplied) that should be applied to the function key to label the function. Ensure
the keypad is clean and dry before affixing the sticker. Refer to Cleaning page 7 for
more information.
11.2. Key Functions
11.2.1.
NONE
When set to NONE the special function key is not used during normal operation.
This is the default setting.
11.2.2.
TEST
Press the <TEST> key to clear the display then show all segments of the display
then clear the display again before returning to normal operation.
11.2.3.
COUNT
Use this key to perform pieces counting. Press the <COUNT> key to switch
between weight display and counts display. The instrument annunciator shows p for
pieces.
To record a new sample do the following:
Tare off any containers.
Place the sample on the scale
Press and hold the <COUNT> key for two seconds. The default number of items
in the sample will be displayed.
Use the <SEL> and <EDT> keys to alter the number of items.
Press <OK> and the current sample will be stored against the entered items.
If printing is enabled the sample quantity and weight will be printed.
11.2.4.
UNITS
Use the <UNITS> key to switch the displayed reading between lb and kg. This will
affect the displayed and printed weight but will not affect any data entry. The
following is a sample of a printout displaying kg and lb.
000009 06/05/2003 16:31
2.8 kg G
000010 06/05/2003 16:31
6.1 lb G