Reference Manual Rev 3.23
Software Versions 3.xx
Page 30
7.1.1. Setup Display Prompts
When accessing Full or Safe Setup the instrument will beep twice and then display
the following:
•
FULL or SAFE (depending on setup access type)
•
SETUP
•
Software Version (eg. V1.0)
•
Calibration Counter (eg. C.00010). Refer to Calibration Counter page 27 for
more information.
•
If a passcode has been configured, the ENTER PASS prompt will display and
the setup passcode must be entered to gain access. Refer to Passcodes page
28, SAFE.PC (Safe Security Passcode for Digital Setup) page 35 and FULL.PC
(Full Security Passcode for Digital Setup) page 35 for more information.
•
The title of the first Group (ie. BUILD) will then be displayed.
7.2. Exiting Full or Safe Setup
To save settings, exit setup and return to the normal weighing mode use one of the
following methods:
Method 1: Press and hold both the <POWER> and <FUNCTION> keys together
for two seconds.
Method 2: Press and hold both the <POWER> and <ZERO> keys together for two
seconds.
Method 3: Press the <GRP> key repeatedly. When - End - displays press <ITM>
or <OK>.
The instrument will beep and then display the following:
•
SAVING
•
Software Version (eg. V1.0)
•
Calibration Counter (eg. C.00010). Refer to Calibration Counter page 27 for
more information (“R” series instruments only).
•
The current weight will then display.
Warning: If the power is interrupted while in setup (ie. by disconnecting the power
cable or pressing the <POWER> key), unsaved settings will be lost.
7.3. Groups and Items
All keypad setup options in the instrument are organised in a tree structure made up
of Groups and Items. To simplify this document, Groups and Items will be notated
as follows (GROUP:ITEM). Refer to Setup Menu Quick Reference page 63 for a
list of all Groups and Items.
7.3.1. GRP (Group)
Setup is divided into a series of Groups. Each group has a distinctive group title.
All options in any one group have related functions. The <GRP> key can be used to
cycle through the available groups.
7.3.2. ITM (Item)
Each group is divided into individual Items. Each item represents a parameter that
can be changed. Pressing the <ITM> key will enter the displayed group, allowing
