TECshow WI NODE, User Manual

Page: 7 / 18

P. 7
- Neo Wi NODE
Rename Device
Enter into the main menu by press MENU, then
pressing the UP and DOWN to choose the Rename
Device option and then press the ENTER to confirm
your selection. Now you can rename the device by
pressing UP and DOWN now. Confirm you change
and move to next option by press the MENU.
SetIP Address
Enter into the main menu by press MENU, then
pressing the UP and DOWN to choose the Set IP
Address option and then press the ENTER to con-
firm your selection. Now you can set IP address by
pressing UP and DOWN now. Confirm you change
by press the ENTER.
Please note: Each of the IP address should be
unique.
Set Netmask
Enter into the main menu by press MENU, then press-
ing the UP and DOWN to choose the Set Netmask
option and then press the ENTER to confirm your
selection. Now you can set Netmask by pressing UP
and DOWN now. Confirm you change by press the
ENTER.
Set DMX port
Enter into the main menu by press MENU, then
pressing the UP and DOWN to choose the Set DMX
port option and then press the ENTER to confirm
your selection. Then you can set the parameter of
the each port by pressing UP /DOWN and ENTER
now.
• 1-2 DMX output: You can enter to any of the
DMX port 1-2 and set as below:
1. Disp Type, adjust the display mode.
2. Port Status, DMX port status can be set as IN /
OUT/ DIS;
3. DMX Mode ,As the DMX port set as Input status,
then the Mode only can be set as normal or
backup; As the DMX port set as output status,
then the Mode only can be set as SINGLE,HTP
or LTP.
4. Protocol, can be set as ArtNet/ sACN/ KlingNet;
5. Framerte/fs, adjust the speed of DMX output.
6. Network, adjust the value.
7. Sub Network, adjust the value.
8. Principal, adjust the value.
9. Secondary, adjust the value.
10. Resend, adjust or disable the value for univer-
sal of network.
11. Pixel Type, available under klingnet protocol.
12. Pixel Width, available under klingnet protocol.
13. Pixel Height, available under klingnet protocol.
Normal mode
means it will send the data received
from DMX IN port to the universal of network re-
gardless if there is any data in the universal of the
network.
Backup mode refers that when there is any data
on the universal of network, the CA-AN08 won’t
send any data to universal of network. Only when
the universal of network is no any data, then the
CA-AN08 will receive the data from DMX IN port and
send it to the universal of network simultaneously.
English version