P. 4
English Version
| Tecshow HALO 1915 XL
First, to fix the stand to the place where it is placed,
and rotate 540° horizontally and 270° vertically.
Caution! Ensure that the installation is perfectly
suitable place to ensure that the chos en mount
point is reliable.
When installing the device, keep it away from
flammable materials (decorative materials, etc.) and
keep a distance of at least 0.3 meters from it.
To install the two lifting lugs to the base of chassis
first, and then to mou nt the light to appropriate place.
For overhead installation, the fixture must be always
secured with a safety wire that can bear at least 10
times the weight of the fixture. You must use a safety
wire with a safety clasp. The safety wire pierced throug
h the hole from the bottom of the light. Then bypass
it, the lamp bracket or other fixtures, and finally, to
insert the end of the safety wire into the safety clasp
and tighten the screw.
3. MOUNTING & INSTALLATION
HORIZONTAL MOUNTING
HANGING MOUNTING
The connection between the light and the controller
or the lights mus bjo3vup t use two core shielded
wires with a diameter of not less than 0.5 mm. Please
use the 3 pin DMX512 output /output to connect the
moving head. The connection between the XLR plug
/ socket and the lead be shown in the diagram below.
Be attention that when connecting the 3 pin XLR plug /
socket cannot contact with the inner shell and
between the wire cores also cannot contact.
Except for the connection shown in the diagram above,
the XLR plug / socket and the XLR control line cannot
be connected in any other way.
4. DMX-512 CONTROL CONNECTION