P. 5
| Tecshow ET Dual
English version
DMX Address Mode
This option is for DMX Address setting, press MENU
to select Addr, press Enter to start setting, Using UP
or Down to choose your desired Address No., Then
press Enter to confirm.
DMX Channel Mode
This option is for setting the unit’s channel mode.
Press MENU to select Chnd, Then press Enter to
start setting, UP or DOWN to select the channel
mode, successively 13CH and 21CH, then press
Enter again to confirm your selection.
• 13CH: 13Channel mode
• 21CH: 21Channel mode
Master/Slave Mode
This option is for setting the unit’s Master-slave
mode. Press MENU to select SLnd, Then press Enter
to start setting, there will show MAST, SL1, Press
UP or DOWN to choose Master or slave, then press
Enter again to confirm your selection.
Special Note:
Line Termination. When longer runs
of cable are used, you may need to use a termi-
nator on the last unit to avoid erratic behavior. A
terminator is a 110-120 ohm 1/4 watt resistor which
is connected between pins 2 and 3 of a male XLR
connector (DATA + and DATA -). This unit is inserted
in the female XLR connector of the last unit in your
daisy chain to terminate the line. Using a cable
terminator will decrease the possibilities of erratic
behavior.
• MAST: Choose the device as master
• SL1: Choose the device as slave
Show Mode
This option is for setting Auto Or Sound Mode, Press
MENU to select ShNd, press Enter to start setting,
Auto & SoUn will show, Choose Auto, the fixture will
auto running, Choose SoUn, The fixture will run
-
ning as the music. then press Enter to confirm your
choose.
Sound Sensitive
This option is for adjusting sound sensibility. Press
MENU, select SEns, press Enter to start setting, UP
and Down to adjust sound sensibility from 0-100,
then press Enter to confirm your choose.
Pan Reverse
This option is set to reverse the Pan direction. Press
MENU, select Pan, press Enter to start setting, UP
and Down to select no or Yes, then press Enter to
Termination reduces signal errors and
avoids signal transmission problems
and interference. It is always asvisable
to connect a DMX termnal (Resistances
120 Ohm 1/4W) between PIN 2 (DMX-) and PIN 3
(DMX +) of the last fixture.
5. DISPLAY MENU
