P. 6
Tecshow Derby Lite |
Stop and
Start
Stop and Start
Through this button pause and restart
Flash
F_(1~11)
Automatic flash explosion, through the key - + key blast-
ing flash speed can by adjusted
DMX
Boot Off
Through the key into the DMX mode and exit DMXmode
- +
Flash Speed
Motor Speed
Through this ket to adjust motor rotation speed and the
critical speed
Notice: Be sure to follow 2 & 3 when making your own
cables. Do not connect the cable´s shield conductor
tto the ground lug or allow the shield conductor
to come in contact whith the XLR´s outer casing.
Grounding the shield could cause a short circuit and
erratic behaviour.
•
When longer runs of cable are used, you may
need to use a terminator on the last unit to
avoid erratic behaviour.
•
Termination reduces signal transmission
problems and interferance. It is always
advisable to connect a DMX terminal, (resistance
120 Ohm 1/4W) between pin 2 (DMX-) and pin 3
(DMX+) of the last fisture.
common
DMX-512 out
3-pin XRL
DMX-512 in
3-pin XRL
XLR MALE SOCKET
XLR FEMALE SOCKET
Figure 3
Figure 2
XLR Pin Configuration
Pin 1: Ground
Pin 2: Negative
Pin 3: Positive
English version
