
P. 3
| Tecshow Beampix 14
English version
Be careful with your operations. With
adangerous voltage you can Suffer a
dangerous electric shock when touching
wire.
This device has left the factory in perfect condition.
In order to maintain this condition and to ensure
a safe operation, It is absolutely necessary for the
user to follow the safety instructions and warning
notes written in this user manual.
Damages caused by the disregard of this
user manual are not subject to warran
-
ty. The dealer will not accept liability for
any resulting defects or problems.
•
If the device has been exposed to temperature
changes due to environmental changes, do not
switch it on immediately. The arising condensa-
tion could damage the device. Leave the device
switched off until it has reached room tem
-
perature.
•
This device falls under protection-class I. There
-
fore it is essential that the device be earthed.
•
The electric connection must carry out by qual
-
ified person.
•
The device shall only be used with rate voltage
and frequency.
•
Make sure that the available voltage is not high
-
er than stated at the end of this manual.
•
Make sure the power cord is never crimped or
damaged by sharp edges. If this wold be the
case, replacement of the cable must be done by
an authorized dealer.
• Always disconnect from the mains, when the
device is hot in use or before cleaning it.
•
Only handle the power cord by the plug. Never
pull out the plug by tugging the power cord.
•
During initial start-up some smoke or smell may
arise. This is a normal process and does not
necessarily mean that the device is defective. It
should decrease gradually.
•
Please don’t project the beam onto combus
-
tible substances.
•
Fixtures can not be installed on combustible
substances. Keep more than 50cm distance
with wall for smooth air flow. So there should
be no shelter for fans and ventilation for heat
radiation.
•
If the external flexible cable or cord of this
luminaire is damaged. It shall be exclusively
replaced by the manufacturer or his service
agent or a similar qualified person in order to
avoid a hazard.
2. SAFETY INSTRUCTIONS